Please note:
Button
Ι
is for the
LOCK/UNLOCK
functions.
Button
ΙΙ
is for the
START/STOP
functions.
Buttons
Ι
&
ΙΙ
(together) is for the
TRUNK
release function.
The LED is NOT included in this model.
Notice
The manufacturer will accept no responsibility for any electrical damage resulting from improper
installation of the product, be that either damage to the vehicle itself or to the Unit. This Unit must
be installed by a certified technician using all safety devices supplied. Please note that this guide
has been written for properly trained Autostart technicians, a certain level of skill and knowledge is
therefore assumed. Please review the Installation Guide carefully before beginning any work.
Warning
This Unit is designed for vehicles with an
automatic
Transmission only. Before installing the
Unit, test that the vehicle does not start when the gear select lever is in the “Drive” position. If it
starts in gear, install a manual-transmission car starter instead.
DOC.1.50
CA –
September 2, 2004
Manufactured in Canada by Autostart
A U T O M A T I C
T R A N S M I S S I O N M U L T I -
C H A N N E L R E M O T E S T A R T E R S Y S T E M
CT-3200
Installation Guide
Table of Contents
Introduction...................................................2
Included in the Package ...............................2
Installation Tools:..........................................2
Before You Get
Started
…........................2
Harness Description .....................................3
6-Pin Main Ignition Harness.....................3
5-Pin Secondary Harness........................4
12-Pin Accessories Harness....................5
Flashing the Hood Pin ..................................7
The Programming Assistance Button (a.k.a.
PAB.) ............................................................8
Before Programming a Transmitter ..............8
How to Program the Transmitter. .................8
How to Enter Programming Options Mode...8
Programming Options...................................9
Auto Tach Programming Procedure.............9
Multi-Speed Tach Programming.................10
Testing ........................................................10
Closing Up ..................................................11
Supplementary Information ........................11
Fifth Relay Output (2nd Ignition or 2nd
Accessories or 2nd Crank Output) .............11
Ignition-controlled Door Locks...............11
Secure Lock...........................................11
Passive or Active Arming Starter Kill.....12
Lock Pulse Duration ..............................12
Engine Run Time...................................12
Idle Mode...............................................12
Resetting the Module (without the plug-in
valet)...........................................................12
Resetting the Module (with the use of the
plug-in valet)...............................................12
Troubleshooting Poor Transmitting Range 13
Installation Order ........................................13
A basic introduction to the Relay:...............15
Troubleshooting Poor Transmitting Range 19
Trouble shooting Q & A ..............................19
Downloaded from
www.Manualslib.com
manuals search engine
