Prosharp SkatePal-Pro, Оригинальное руководство пользователя

Страница: 9 / 12

Figure skate sharpening
PUT ON YOUR EAR EYE AND BREATHING PROTECTION BEFORE PERFORMING
FOLLOWING STEPS!
Take the grinding wheel door off and make sure that the smaller 60 mm wheel is installed, it
should say “FIG” on it. Put the bridge in the toe end side of the slot and put the lowest spike
in the bridge, then clamp the skate firmly, make sure it is not easily moved.
Look inside the machine to make sure that the heel sits around 2-3 mm below the clamping
steel, that way it will not damage the clamping steels, and not round the heel of the skate.
Then carefully take away the toe protector device, press and hold the start/stop button, and it
will drive the grinding wheel towards the toe picks without the grinding wheel spinning.
This will allow you to make sure that the grinding wheel will miss the toe picks, and also at
what point it will hit the heel of the skate. When you release the button it will stop and when
you push again, it will return to start position. It will take some adjustment before you can
obtain a satisfying result so please be patient, after you have found the correct setting it will
not be necessary to adjust it anymore for your SkatePal, so make sure you have tightened
the nuts firmly. When you are ready to start sharpening continue to the first page.
A tip is to start by using an old skate,
that way you will not take the risk of damaging more expensive skates.
ProSharp Toe Pick protector is
not included with the machine,
call us, or visit our website for
details.
To make the wheel
come further away
from the toe picks,
adjust the screws
down.
Adjust the height in
small steps by using a
7mm spanner.
To make the grinding
wheel come closer to
the toe picks, adjust
the screws up.