for all your filter requirements
Phone: 01422 377367
email: [email protected]
www.prosep.co.uk
Prosep Filter Systems Ltd
Unit G19, River Bank Way,
Lowfields Business Park,
Elland, West Yorkshire
HX5 9DN
SYSTEM START UP:
Turn on the cold water supply at the stopcock and turn the cross piece on the saddle tap valve
anti-clockwise to fully open. Close the tank ball valve. Open the tap for continuous flow (Lever
to the side). Check the system for leaks, tighten as necessary. Connect the pump to a power
supply and turn on. After 10-30 minutes, water will start to drip out of the tap. Let it drip for
about 10 minutes and then turn the tap off. TURN ON THE TANK BALL VALVE NOW. It may
now take 2-4 hours for the storage tank to completely fill.
Note:
DO NOT DRINK THE WATER FROM THE FIRST TANK PRODUCED BY YOUR NEWLY PURCHASED
REVERSE OSMOSIS SYSTEM.
After the tank is full (you will hear the water stop), flush the system by placing the tap in the
open position until all the water is completely discharged. Upon complete discharge of the
storage tank, return the tap handle to the closed position and let the refilling process begin.
This process could take 2-4 hours to complete. After the second tank is filled, you may enjoy
the pure water. Check for leaks daily for the first week and periodically thereafter. You may
notice that the water may be milky coloured during the first week. This is caused by air bubbles
in the water released from the carbon filter, they will dissipate on allowing to stand. It is normal
and safe.
NOTE:
DO NOT USE WITH WATER THAT IS MICRO BIOLOGICALLY UNSAFE OR OF UNKNOWN QUALITY WITHOUT
ADEQUATE DISINFECTION BEFORE OR AFTER THE SYSTEM. SYSTEMS CERTIFIED FOR CYST
REDUCTION MAY BE USED ON DISINFECTED WATER THAT MAY CONTAIN FILTERABLE CYSTS.
THIS REVERSE OSMOSIS SYSTEM CONTAINS A REPLACEABLE COMPONENT CRITICAL TO THE
EFFICIENCY OF THE SYSTEM. REPLACEMENT OF THE REVERSE OSMOSIS COMPONENT SHOULD BE
WITH ONE OF IDENTICAL SPECIFICATIONS, AS DEFINED BY THE MANUFACTURER, TO ASSURE THE SAME
EFFICIENCY AND CONTAMINANT REDUCTION PERFORMANCE.
WARNING:
DO NOT USE THIS SYSTEM TO PURIFY NON-DRINKABLE SOURCES OF WATER THAT
ARE UNSAFE OR WITH WATER OF UNKNOWN QUALITY
WARNING:
NEVER USE HOT WATER OR ALLOW THE UNIT TO FREEZE.
WARNING:
INCORRECT INSTALLATION WILL VOID THE WARRANTY.
