8
Note:
1）
Clamp two lines of the measured circuit or more at the same time will not
obtain correct measurement results.
2）
To obtain accurate readings, try to enable the measured cable in the middle
position of the current clamp.
3）
In the maximum capture current mode, the meter only measures current, it
will not measure voltage and resistance at the same time.
4.6 Non-contact Voltage Detection (NCV)
1）
Press PMAX/NCV key for 2s, enable NCV function, the meter displays
2）
Press NCV key, put the NCV sensor close to the measured cable, the meter
could detect if the measured cable is >90V AC voltage or not. When the meter
detects AC voltage, the meter buzzer alarms and the backlight flashes.
Note:
3）
Even there is no alarm indication, the voltage might still exist. Do not judge if
there exist voltage or not in the cable relying on non-contact voltage detector.
The detection operation might be affected by various factors such as the
socket design and insulation thickness types are different and so on.
4）
In NCV detection mode, the meter will not measure the voltage, resistance
and current at the same time.
4.7 AC Current Measurement
1）
Hold the trigger, open the clamp head and clamp one cable of the measured
circuit.
