Fitting Kit
EN
K671
●
Now cut the rubber insert at the 2 lines you
marked in the earlier instruction. Once cut
you should end up with 4 x 50mm pieces of
the rubber insert.
●
Note: Be careful of sharp edges after
cutting the rubber insert.
●
Remove one side of adhesive tape
backing. Apply to underside of rubber
insert as shown. Remove second backing,
then apply downward pressure onto
vehicle.
●
To reveal the screw thread in the mounting
points, remove the sealant covering them
with a sharp tool.
8
Содержание K671
Страница 2: ...Fitting Kit K671 x 4 x 4 x 4 x 4 x 4 2 ...
