
Start USING YOUR SYSTEM
What your Propur™ Scout includes:
1-Upper Container
1-Lower Container
1-Filter Element, wing nut & washer
1-Scrubby sponge
There is NO spigot required for the Scout
Cleaning
System
1) Wash your hands.
2) Use liquid dish washing soap along with the
yellow side of the enclosed scrubby sponge to
clean the stainless steel parts of your unit.
Warning:
Do not use rough side of sponge on
stainless steel system.
Filter
1) Wash your hands.
2) Remove the filter(s) from packaging.
3) Hold the filter(s) by the plastic base. Run the
ceramic under cool running water.
4) Scrub the filter with the rough (green) side of
scrubby sponge. Rinse well.
Warning:
Do not use any soap on the filter.
Do not allow water to go up the stem of the filter.
Installing the filter
1) Place the washer onto the stem of the filter.
2) Place the filter stem through hole in the upper container.
3) Install wing nut on the underside of the upper container.
DO NOT OVER TIGHTEN
4)Place upper container onto lower container.
SCOUT
1) Make sure spigot is in off position.
2) Pour water into upper container.
Warning:
LOWER CONTAINER SHOULD BE EMPTY BEFORE REFILLING
UPPER CONTAINER
. ONLY USE COOL WATER IN THE SYSTEM
3) Allow water to drip into lower container.
4)
DISCARD THE FIRST 2-3 CYCLES OF WATER.
Recommended Propur™ system use and maintenance
1) Wash the upper and lower containers once every 2-3 months with
liquid dish washing soap by hand.
DO NOT USE DISHWASHER MACHINE SOAP.
2.) Clean the filters regularly to keep at optimal flow rate.
8