2.0 Conditioning The Filter
Your System should now be ready to condition the filter.
1.
To avoid issues caused by air locks, hold the unit upside-down in the kitchen sink.
2.
Turn on the cold tap with low to moderate pressure, rotate the selector(2) on the
diverter valve to allow water to slowly fill the unit for the first time. It may take a few
minutes for water to flow through the outlet arm (5).
3. Once water begins to flow through the outlet, place System on counter next to sink
and allow water to run to waste for a minimum of 10 minutes, or 3 gallons*. This will
expel any trapped air, remove any carbon fines from the manufacturing process,
and condition the filter for use
*DO NOT DRINK THIS WATER. ALLOW IT TO GO TO WASTE.
4.
After this procedure is complete, the System is now ready for use.
3.0 How To Use Your System
1. When you desire water from your System, rotate the selector (2) on the
diverter valve (2) allowing water to flow through the System and exit the outlet
(spout). May drip after you turn off diverter or faucet for a few drips.
4.0 How To Replace The Filter Cartridge
1.
With the cold tap turned off, hold the filter unit upside-down over the sink.
2.
Unscrew the body (4), which will be full of water, from the base (6). The cartridge
(9) can now be removed by gently pulling it away from the base (6). The filter car-
tridge does NOT require cleaning.
3.
After a new filter cartridge (9) has been re-installed, recondition the filter as de-
scribed in 2.0. Hand tighten the body (4) onto the base (6).
ProMax
™ Countertop System Specifications
Type of installation: Counter top
Maximum Working Pressure: 860 Kpa (125 psig)
Minimum Working Pressure: 62 Kpa (10 psig)
Maximum Working Temperature: 38° C (100° F)
Minimum Working Temperature: 5° C (41° F)
Recommended Flow Rate: 0.2 – 1.0 gpm
Contaminant Reduction: Refer to Lab Report
Filter Life Expectancy: Up to 1 year
Replacement filter: PMC34RF
FAQ’s
How do I know when to replace my filter cartridge?
When the flow rate diminishes
When you notice a change in taste or odor
Approaching a years’ usage
What if I don’t use the System for an extended period of time
We recommend you drain your System and remove
the filter element
When ready to use, just reinstall the filter and flush for
about 10 minutes before use
How long will my filter last before needing to be replaced
The actual life expectancy of your filter will vary depending
on the specific chemistry and level of contaminants present in your wa-
ter source
