Basic Installation
Step 1 - Install Filter Housing
1. Select a suitable location for the filter housing under the sink.
NOTE: location should be reasonably accessible for filter replacement.
When mounting housing to cabinet, make sure to leave enough space below
sump/filter housing for removal of sump (min. 2 inches) for maintenance and
filter replacement.
DO NOT INSTALL where temperatures fall below freezing as damage to the
system will occur.
2. Install the filter bracket (white steel) on the filter head (white plastic) using the
four (4) small screws.
NOTE: The flow arrow and inlet/outlet are embossed on the top of the white
plastic head.
3. Secure the bracket with the filter housing assembly to the side of the sink
cabinet in the desired location with the two (2) self-tapping screws.
Step 2 - Install Line Piercing Needle/Saddle Valve (Not Included)
1. Make sure your cold water supply has been turned off. If there is no valve, turn
off the water supply to your house at the main meter.
2. Attach the line piercing needle/saddle valve per instructions to the cold water
line going to your sink faucet.
NOTE: Do NOT turn the cold water line back on yet, as water will flow directly
out of the valve and flood your kitchen.
2