About the Alarm
Kit contents:
• 1 x PIR alarm
• 1 x Remote Control
• 1 x Ball-head joint mounting bracket
• 2 x Screws and Wall Plugs
• 1 x Instruction Leaflet
IMPORTANT – Read before installing
• Do not expose any part of the alarm unit to any sudden shocks
(such as being dropped or struck).
• Do not install the passive infrared (PIR) alarm unit within detection range of any device
which emit heat or cold, such as air conditioners, refrigerators, ovens, heaters,
microwaves or other electronic equipment which generates heat.
• Do not install the PIR sensor in direct sunlight.
• Use only alkaline batteries.
• Do not install outdoors.
• Test the alarm periodically (every 1 – 2 months) to ensure it is working properly.
• This alarm cannot offer complete protection for your home or business – it is simply an
alarm system.
Setting up the Alarm
Installing batteries
The remote controlled PIR Alarm requires 3 x AA alkaline batteries (not included). To install
batteries:
• Remove the screw at the base of the battery compartment and slide off cover.
• Insert 3 x AA alkaline batteries noting the polarity diagram inside the compartment.
• Replace the cover and screw closed.
Note: A slow flashing of the red light on the front of the alarm indicates that the batteries
are low, and need to be replaced.
The Remote Control requires 1 x CR2032 cell batteries (included).
To replace the battery:
• Slide off the back cover
• Carefully remove the clear plastic insulation tab from the batteries. If the batteries are
dislodged, replace them noting the polarity diagram inside the battery compartment.
• Slide the cover back onto the battery compartment.
IMPORTANT:
• Remove batteries before storing the alarm for long periods of time. Batteries corrode over
time and may cause permanent damage to the unit.
• Different types of batteries or new and old batteries should not be mixed.
• Depleted batteries should be removed from the unit and disposed of properly.
