SPYDER X™ QUADROCOPTER DIAGRAM
SPYDER X™ REMOTE DIAGRAM
Speed Setting
Throttle Trim
Adjustment
Throttle & Spin
Left/Right
Right/Left Spin
Trim Adjustment
Power Switch
Power Indicator
Antenna
360º Flip Button
Forward/Backward
Bank Left/Right
Forward/Backward
Trim Adjustment
Bank Right/Left Trim
Adjustment
E
3
4
FLIGHT PREPARATION
• Verify that there are 6 “AA” batteries inside the remote control unit and the Spyder X™ has been
fully charged.
• Make sure your Spyder X™ and controller are both turned on.
• Make sure to be in a large space with an open radius of at least 100 feet.
• Make sure the empty space has no obstacles. Set your Spyder X™ on a clean flat surface before take-off.
DO NOT ATTEMPT TO FLY YOUR SPYDER X™ IF THERE IS RAIN, SNOW, HEAVY WINDS, THUNDER OR LIGHTNING
OUTDOORS. IT COULD DAMAGE YOUR PRODUCT AND POSSIBLY EVEN CAUSE BODILY HARM.
SYNCING YOUR SPYDER X™
Important! When syncing your SPYDER X™ quadrocopter with the controller always make sure that
the quadrocopter is on a flat level surface and that your digital trim settings are in the center
position. This insures that the 6 Axis gyro is properly programmed to mimic your trim settings.
Your Spyder X™ utilizes an automatic 2.4G channel selection system that allows up to 8 people to fly side
by side in the same wireless range with no interference.
Syncing your aircraft:
1. Before starting, make sure that the power on your controller is in the OFF position and the Spyder X™
wire leads are not connected. Make sure that there are no other 2.4G devices in the area as well .
2. Connect the battery wire lead to the Spyder X™ lead and set it down on a flat surface.
The LED indicator lights of the Spyder X™ should begin to flash (see diagram E).
3. Turn ON the remote, you will hear a beep, the Spyder X™’s flashing LED lights should change to
solid, push the throttle on the left all the way forward and then slowly pull the throttle all the way back.
You will hear 2 beeps and your controller should now have a solid red light. If not , repeat the above
steps.
FLYING TIPS
• It is recommended that you operate the Spyder X™ in a wide space. The ideal space should have a
200 foot radius.
• Parental guidance or adult supervision is suggested at all times.
• If you are flying the Spyder X™ with others, make sure all spectators are behind you.
• For best performance, it is recommended that you operate the Spyder X™ in zero wind conditions.
Wind can greatly affect the performance of the aircraft or cause injury.
DO NOT FLY YOUR SPYDER X™ IN FOUL WEATHER!
WARNING
Propeller Guard
Propeller Blade
Li-Poly Battery Compartment
Landing Gear
