NEUTRON™ DIAGRAM
REMOTE DIAGRAM
FLYING TIPS
• It is recommended that you operate the NEUTRON™ in a wide space. The ideal space should have a
200 foot radius.
• Parental guidance or adult supervision is suggested at all times.
• If you are flying the NEUTRON™ with others, make sure all spectators are behind you.
• For best performance, it is recommended that you operate the NEUTRON™ in zero wind condition.
Wind can greatly affect the performance of the NEUTRON™.
Important! When syncing your NEUTRON™ quadrocopter with the controller always make sure that
the quadrocopter is on a flat level surface and that your digital trim settings are in the center
position. This ensures that the 6 axis gyro is properly programmed to mimic your trim settings.
Your NEUTRON™ utilizes an automatic 2.4G channel selection system that allows up to 8 people to fly side
by side in the same wireless range with no interference.
For One Person Play:
1. Before starting, make sure that the power on your controller is in the OFF position and the NEUTRON™’s
battery is disconnected. Make sure that there are no other 2.4G devices in the area as well.
2. Connect the NEUTRON™’s battery and set it down on a flat level surface. The white LED indicators on
the top of the body should begin to flash.
3. Turn ON the remote, you will hear a dual beep, the white LED lights on the drone should change to
solid. Pull the throttle all the way up and then all the way down. Two beeps signal that your controller and the
quadrocopter are successfully synced. Should this not happen, repeat above steps again.
For Multi Person Play:
4. Before starting, make sure that the power on all NEUTRONs and Controllers are OFF. Make sure that
there are no other 2.4G devices in the area as well.
5. Each person will have to sync his NEUTRON™ individually at a different time to avoid interference.
Follow steps 1 to 3 above making sure to keep away from other people and no one else is syncing at the
same time.
6. After syncing a player’s NEUTRON™, it should be left ON until all players have synced their quadrocopters.
7. Should there be a mistake/interference, all players must turn off their controllers and
quadrocopters for 60 seconds and then begin the process again.
NOTE: If there is no microSDHC card inserted in the Drone, the red LED’s will flash constantly.
SYNCING YOUR NEUTRON™
• Verify that there are 2 “AAA” batteries inside the remote control unit and the NEUTRON™ has been fully charged.
• Make sure your NEUTRON™ and controller are both on.
• Make sure to be in a large space with an open radius of at least 50 feet.
• Make sure the empty space has no obstacles and bodies of water. Set your NEUTRON™ on a clean level flat surface
before take-off.
DO NOT ATTEMPT TO FLY YOUR NEUTRON™ IF THERE IS RAIN, SNOW, HEAVY WINDS, THUNDER OR LIGHTNING
OUTDOORS. IT COULD DAMAGE YOUR PRODUCT AND POSSIBLY EVEN CAUSE BODILY HARM.
PREPARING FOR FLIGHT
3
4
Safety Cage
Front Rotor Blades
(Gray Color)
Landing Gear
Digital Camera
Rear Rotor Blades
(Black Color)
microSDHC Card
Socket
Battery
Compartment
DO NOT FLY YOUR DRONE IN FOUL WEATHER!
WARNING
Speed Setting Button
Speed Indicator
Throttle/Yaw
360˚ Stunt Rolls Button
Direction Control
Power On/Off
4 CH Mode
3 CH Mode
Left Bank Trim
Right Bank Trim
Forward Trim
Camera/Video
Power Indicator
Backward Trim
CALIBRATE
VIDEO
CAMERA
STUNT
START/LAND
SPEED
4CH
3CH
1 2
T
3
H
3 4 C
