Propel Trampolines K-PROPL-CSPck-0001, Инструкция по эксплуатации

Страница: 5 / 12

Turn the Drive Sleeve clockwise to adjust the length of the Brush protruding
from the Shroud. For optimal performance, 1/2” – 5/8” of the Brush is only
required to be exposed.
1. Dip the Brush into the Weld Cleaning fluid, making sure the Brush is soaked.
2. Apply the tip of the Brush to the workpiece and use small circular motions
over the area to be cleaned, until the desired result is achieved. Do NOT push
down on the Brush. This will not improve the cleaning performance and will
result in premature Brush wear.
3. As the Brush wears, adjust the length by turning the Drive Sleeve clockwise
(see figure 2)
. When the Brush is unable to protrude 1/2” – 5/8” from the tip
of the Shroud, replace the Brush by following the ‘Installing & Replacing the
Brush’ Instructions.
Important! Do not allow the Brush to dry out during use. Re-dip the Brush as
required to keep it wet during use. Cleaning with a dry Brush will result in an
increase of Brush sparking and will leave Brush burn marks on the workpiece.
Operating the PROPEL Torch
5
Figure 2
Drive Sleeve