Propel Trampolines K-PROPL-CSPck-0001, Инструкция по эксплуатации

Страница: 4 / 12

1.To install or replace the Brush, turn the Drive Sleeve clockwise until it stops.
Do NOT overwind the Drive Sleeve!
2. Insert the brass end of the Brush into the nose of the Shroud until it is seated
in the Collet. The Brush should slide into the Collet with minimal resistance
(see figure 1)
.
3. Once the Brush is seated in the Collet, turn the Drive Sleeve anti-clockwise
half a turn, and lightly pull the Brush to ensure it is securely seated. Now that
the Brush is secure, retract the Brush back into the Shroud by turning the
Drive Sleeve anti-clockwise, until it leaves approximately 1/2” – 5/8” of the
Brush exposed.
4. When the Brush requires replacement, repeat steps 1- 3 for Brush
replacement.
Note:
If the Shroud becomes warped due to overheating the Brush will become
difficult to fit or remove. To prevent this, make sure the Brush does not dry out
while in use.
Warning! The Brush may be extremely hot from use.
Installing & Replacing the Brush
4
Figure 1
Brush
Shroud