SUBMENU
SUBMENU IS ACCESSED THROUGH THE MAIN MENU. FIRST GO TO THE APPROPRIATE LEVEL OF THE
MAIN MENU AND THEN FOLLOW THE INSTRUCTIONS IN THE PROGRAMMING FLOW DIAGRAM TO
ENTER THE SUBMENU. PRESS THE “MODE” AND “UP” OR “MODE” AND “DOWN” BUTTONS
SIMULTANEOUSLY FOR 5 SECONDS TO ENTER THE SUBMENU AND ONE BUTTON AT A TIME WHILE
IN THAT SUBMENU.
OPTION:SELECT PPR:
(Pulses Per Revolution) Select the PPR value by pressing “Down or “Up”
button to move dial pointer to corresponding RPM. For additional information see the Tachometer
Sense Line Attachment and Meter Setting section on page 4.
OPTION:RESTORE FACTORY DEFAULT:
TO RESTORE FACTORY DEFAULTS, PRESS THE
:MODE” BUTTON ONCE TO ENTER THE
PEAK PLAYBACK
.
THEN PRESS AND HOLD THE “MODE” AND
“UP” BUTTONS FOR FIVE SECONDS. Activation of the Default will erase all field calibration setup
settings that are programmed. Factory calibrations will not be affected.
OPTION A:DEMO MODE:
Displays the features of the meter. The pointer goes up and down
the scale, the dial colors change and the
HI
,
LOW
and
PEAK
warning indicators light. The Demo
mode does not time out. If the gauge is turned off in the Demo mode, it will start up in the Demo
Mode. Press the “Mode” button to return the gauge to NORMAL operation.
OPTION: POINTER BRIGHTNESS MODE:
The “Down” and “Up” buttons adjust the dial
pointer brightness to blend in with original manufacturer’s gauges and the owner’s requirements
Press the center MODE button to save the setting and return to
NORMAL OPERATION
PROGRAMMING INFORMATION:
• TO RESET THE PROGRAM TO NORMAL OPERATION FROM ANY MODE PRESS THE “UP” AND “DOWN”
BUTTONS SIMULTANEOUSLY. THIS SOFT RESET CANCELS THE INFORMATION YOU PROGRAMMED IN
THAT MODE ONLY AND RETURN YOU TO NORMAL OPERATION.
• THE FACEPLATE WILL “FLASH” WHEN BUTTONS ARE DEPRESSED TO ACKNOWLEDGE COMMANDS.
• PROGRAMMING ERRORS WILL BE SIGNALLED BY FLASHING THE FACEPLATE LIGHTING “
PURPLE
”,
“
BLUE
”, “
GREEN
” THEN “
ORANGE
”.
• IF PROGRAMMING IS INACTIVE FOR 60 SECONDS THE MODE WILL TIME OUT AND THE GAUGE
WILL RETURN TO NORMAL OPERATION, EXCEPT FOR THE DEMONSTRATION MODE. THE DEMO
MODE WILL NOT TIME OUT UNTIL THE CENTER “MODE” BUTTON IS PRESSED IF THE GAUGE IS
TURNED OFF IN THE DEMO MODE, IT WILL START UP IN THE DEMO MODE.
Programming Instructions for : RPM Tachometer
2
1/16
” Controller
7
