ProofVision 19 inch Waterproof TV, Руководство пользователя

Страница: 2 / 16

ProofVision
“Making it work in challenging conditions”
INSTALLATION MANUAL
It is the installer's responsibility to ensure that your waterproof LED TV is installed and sealed
correctly. Your warranty becomes void if problems occur due to faulty installation or poor
sealing.
1. Decide on the correct position for your TV. Test the TV in that position to make sure the
viewing angle is appropriate for the viewing position. Each waterproof TV model has specific
viewing angles. Position the front bezel in order to view the picture clearly from all intended
areas. Should there be any doubt, make the area safe and power up the LED, positioning the
screen until satisfied that the picture does not darken or disappear from view as close to eye
level as possible.
2. Once you have your position check for any hazards that may stop you installing in this area,
i.e. cables or pipes. When mounting in stud walls, check for any supporting framework behind
the plasterboard.
3. Use the table below to work out the cut out size within the wall to fit the TV. The recess in
the wall should be the cut to the size of the mounting plate dimensions.
4. Open up the cable cover by unscrewing all 8 screws, connect the power cable and the aerial
(RF cable) and also any other desired cables. Place the cable cover back, in line with the holes
and screw it back into place, making sure that it is secure and tight. Chase all cables into the
wall at the bottom of the TV to reduce chances of water reaching the TV.
5. When all the material is removed within the dimensions detailed to suit your size of the TV.
Use the screws provided to fix the mounting case in place. Make sure the edges of the
mounting case are directly in line with the wall or tiles. Also make sure the mounting case is
securely fitted as this supports your TV unit.
6. Now the TV is connected check that all the functions of the TV are working before fitting.
The signal level feed to the TV must be at least 65db/1 mill volt or the picture may be noisy or
pixelated and difficult to tune. A distribution amplifier may be required if you are in a weak
signal area. If in doubt, consult a qualified aerial technician.
7. Apply a continuous unbroken bead of clear waterproof silicon around the inside of the
television bezel at least 5mm thick. Use clear, mould resistant waterproof bathroom sealant.
All models do not require any ventilation considerations.
8. Offer the television to the wall cut out and place the TV into the back plate, push the TV