12 Adjusting Screw PA5
11 Magnet
10 Switch PCB
9 Angle Bracket
Stainless Steel
8 Screw
Stainless Steel
7 Bottom Plate
Styrosun
6 Mounting Screw Stainless Steel
5 Battery Box
ABS
4 Transmitter Box ABS
3 Spoon
PA5
2 Housing
Styrosun
1 Funnel
Styrosun
Pos Name
Material
RAIN GAUGE PARTS
ADJUSTING THE RAIN GAUGE
THE RAIN GAUGE HAS BEEN ADJUSTED
FROM THE FACTORY BUT CAN EASILY BE
CHECKED AND READJUSTED.
TO DO THIS POUR 0.1 LITRE OF WATER
SLOWLY ( OVER 5 MINUTES ) THROUGH
THE FUNNEL.
THE DISPLAY SHOULD NOW SHOW 20 mm
AS THE COLLECTING AREA
OF THE GAUGE
IS 50 cm².
ANY NECESARRY ADJUSTMENT CAN BE
DONE AS FOLLOWS:
DISMANTLE THE GAUGE AS DESCRIBED IN
CHAPTER X.X . WITH A SCREW DRIVER SET
THE ADJUSTMENT SCREW T OR -
THE ADJUSTMENT SCREW REGULATES
THE QUANTITY OF WATER WHICH MAKES
THE “SPOON” TIP.
¼ REVOLUTION OF THE ADJUSTMENT
SCREW INCREASES OR DECREASES THE
COUNTED VALUE BY APPROXIMATELY 5%
AS SHOWN IN BOTTOM PLATE DRAWING.
AFTER ADJUSTMENT CHECK AGAIN BY
POURING WATER THROUGH THE GAUGE
