LED INDICATORS
OPEN BATTERY BOX ON
DISPLAY UNIT BY SLIDING DOWN
BATTERY BOX COVER.
REMOVE BATTERY INSULATION
PAPER.
THIS SHOULD TURN ON THE
DISPLAY LOOKING AS SHOWN
BELOW WITH FLASHING “----“
IN LINE 3 ( OUTTEMPERATURE )
AND LINE 5 (RAIN TODAY)
INDICATITING THAT THE UNIT
IS SEARCHING FOR REMOTE
SENSORS TO REGISTER
THE UNIT WILL SEARCH FOR
REMOTE SENSORS TO REGISTER
FOR 3 MIN.
NOW YOU CAN REMOVE THE BATTERY INSULATOR PAPER FROM THE REMOTE
SENSORS.
WHEN THE TEMPERATURE CHANGE EQUALS OR IS OVER 0.5 (WITH REFERENCE TO
LAST READING) THE TEMPERATURE SENSOR WILL TRANSMIT READINGS TO THE
RECEIVING UNIT AT 30 SECOND INTERVALS.
WHEN THE RAINFALL CHANGES WITH AN INTERVAL OF OVER OR EQUAL TO 30
SECONDS THE RAINFALL SENSOR WILL TRANSMIT READINGS TO THE RECEIVING
UNIT. IF THERE IS NO RAINFALL THE SENSOR WILL TRANSMIT TO THE RECEIVING
UNIT AT 5-8 MINUTE INTERVALS.
IF YOU PRESS THE “TX” BUTTON ON THE SENSORS WITH THE TIP OF A BALL PEN OR
SIMILAR YOU CAN FORCE THEM TO TRANSMIT A SIGNAL TO THE RECEIVING UNIT.
THE RED LED INDICATORS ON THE SENSORS WILL LIGHT UP WHEN THE SENSOR IS
TRANSMITTING.
IF THE UNIT FAILS TO REGISTER ONE OR BOTH SENSORS WITHIN THE 3 MIN. YOU
CAN FORCE IT TO SEARCH AGAIN.
PRESS AND HOLD “HRS” BUTTON FOR 3 SEC TO MAKE UNIT SEARCH FOR
TEMPERATURE SENSOR.
PRESS AND HOLD “MIN” BUTTON FOR 3 SEC TO MAKE UNIT SEARCH FOR RAIN
SENSOR.
OBS! WHILE UNIT IS SEARCHING FOR SENSORS, ALL OTHER BUTTON
FUNCTIONS IS DISABLED.
WHEN THE UNIT HAS FOUND THE REMOTE SENSORS YOU CAN MOUNT THE
BATTERY COVERS FOR ALL UNITS AGAIN.
WHEN MOUNTING RAIN SENSOR HOUSING ON BOTTOM PLATE BE CAREFULL TO
PLACE WIRES SO THEY ARE NOT DAMAGED AND SO THAT THE TIPPING SPOON
IN THE SENSOR CAN TIP FREELY.
NOW YOU CAN PROCEED TO SETTING THE TIME AND GETTING AQUA??? WITH
THE BUTTON FUNCTIONS ON YOUR WIRELESS WEATHERSTATION. FOR
INSTRUCTIONS ON THIS SE CHAPTER X.X & X.Y
