PROMULTIS Totem Focus, Инструкция по эксплуатации

Страница: 6 / 30

Identification of Controls
4
Remote Sensor
1
2 3
1.USB1/2 for the OPS
2.WiFi antenna for the OPS
3.LAN for the OPS
Enable connection to cable and log on to Internet.
4.Power Switch
Push to (
1
) to connect the power, push to (O ) to cut off the power.
Note :
5.AC IN
Plug the AC cord into this jack and into a power outlet. (~100-240V 50Hz/60Hz
)
Note: USB port, WiFi, LAN port is extended from the OPS, this port and the port on the OPS choose one to use.
Do not cover the Power switch, it should be kept free from coverings so that it can be easily and conveniently
operated.
Power Indicator
USB1
USB2
SWITCH AC IN
4 5
Camera
Note : It can perfectly support camera’s up to 720p.
Open the back cover with the key.
Note: 1.Cut off power before opening the
back cover.
2. Make sure that the back cover is
locked before turning on power.
70 498
87
4- 15
70
87
The totem must be secured to building structure
before operation
.
As illustrated in figure, positioning 4 holes on
the earth and drill the holes at the
corresponding position.
The diameter of the hole on the earth should
be smaller than the diameter of the screw.
Fit the four fastening screws
,
fastening the totem
to earth.
Notes: 1.The appearance of this product in these illustrations may differ from
your actual product, and is for comparative purposes only.
2.We may change the design and specifications without notice.
Fastening the totem