63
i
nStALLing
the
neW
poWer
SuppLy
To install the power supply:
1. Carefully slide the power supply into the enclosure until the levers on each side catch on each side of the
power supply.
2.
Push both levers in to firmly seat the power supply into the enclosure. Both levers will latch to the
enclosure so that the levers cannot be pulled out unless you release the latch.
3. Plug in the power cord.
4. Switch on the power supply.
Verify that the
DC
and
AC
LEDs are green.
This completes the power supply replacement procedure.
Pull both levers backward and outward, the module should slide out easily
12G SAS JBOD
User Guide
Содержание VTrak J5000 Series
Страница 28: ...Drive slot numbering on VTrak J5300 Drive slot numbering on VTrak J5320 21 12G SAS JBOD User Guide ...
Страница 36: ...DB 9 pinout for RJ 11 to DB 9 serial cable 29 12G SAS JBOD User Guide ...
Страница 94: ...87 VTrak J5800 Zoning Configuration 3 Four zones divided access 12G SAS JBOD User Guide ...