5.3 M-module diagnostic
You can immediately view an overview of all the parameters set in
the M-module with a diagnostic. The values are updated every 5
seconds.
A-module (DXMaA) diagnostics
A3196
Factory settings
Pool description 1
Module is reset to factory settings!
R1:
Pump for pH raising agent
Update in 0 seconds
0.0 mA
14.40 mA
13.58 mA
23.00 mA
180
strokes/min
180
strokes/min
180
strokes/min
maximum frequency
Functions
Iout4:
Measured value of combined chlorine mA output
Iout3:
Measured value of chlorine mA output
Iout2:
Measured value of ORP mA output
Iout1:
Measured value of pH mA output
K3:
NO
Error at the pump
K2:
NO
Error at the pump
K1:
NO
Error at the pump
R3:
Pump for flocculant
R2:
Pump for chlorine raising agent
Fig. 8: Diagnostic of the M-module
5.4 Factory setting of the M-module
You also have the option of resetting the M-module to factory set‐
tings.
Press
‘Factory settings’ , as shown in Fig. 8, and follow the
instructions.
ð
You need to re-parametrise the module if you reset a
module to factory settings.
5.5 Configuring Eco!Mode operating mode
[Eco!Mode] operating mode is not set up in the M-module but in a
sub-menu of the respective measuring channel.
1.
To do so, switch to the tile view of the measured values and
select the corresponding measured value.
2.
The
‘Setpoints and parameters’ selection menu is located in
the sub-menu of the measuring channel. The
[Eco!Mode] tab
lists the settings for the second controller set of parameters
for Eco!Mode.
Configuring the M-module (DXMaM, measurement module)
17
Содержание DULCOMARIN 3 Compact
Страница 27: ...27 ...
