8
3
Figure 1
Figure 2
Figure 3
USER'S GUIDE
OPEN
LOCK
LOCK
OFF
LOCK
OFF
OPEN
PUSH
LOCK
PUSH
6.3 Body Pack Transmitter
PARTS DESCRIPTION & SPECIFICATIONS
4. Specifications
25MHz
0.005%
-95dBm S/N
40dB
90dB
100mV
5mV
100dB
1%(AF=1KHz)
LCD
DC 12-15V
25MHz
0.005%
FM
55dB
25K
DC 9V
40mA
10mW
LCD
Frequency Bandwidth
Frequency Stability
Modulation
Spurious Emission
AF Modulation
Power Source
Current Consumption
Transmitting Power
Function Display Mode
Frequency Range
Oscillation Mode
Frequency Number
Frequency Response
Receiving Range
614MHz-806MHz
PLL synthesized
256
50Hz-20KHz
100m
Frequency Bandwidth
Frequency Stability
Sensitivity
Adjacent Channel Rejection
AF Output
SNR
Distortion
Function Display Mode
Power Source
4.1 General
4.2 Receiver
4.3 Transmitter
(1)
(3)
(2)
(4)
(5)
(6)
(7)
(8)
(9)
(Top View)
(LCD Display)
(Front View)
B. Body Pack Transmitter
(1) MIC-IN Jack
(2) Gain Control
(3) Small Screwdriver
(4) CH LCD display
a. GP number b. CH number
(5) GP: Group set button and
GP/CH adjust (UP).
(6) CH: Channel set button and
GP/CH adjust (DOWN).
(7) Power Switch
(8) Battery Compartment / Cover:
Insert 9V battery.
(9) Antenna
4. Channel adjust: Press CH button(4)for about 3 seconds, CH number on LCD will
flash; release CH button (4), press GP button to move CH UP or CH button to move
CH down.
5. After adjusting Group or Channel, release all buttons, group or channel will flash
about 3 seconds and then stop, frequency will be locked and saved.
6. Adjust microphone's GP and CH (according to above procedure 3,4,5) to make the
frequency same as receiver.
7. After 30 seconds if no buttons are pressed, LCD will display battery power. Press
GP button or CH button, LCD will show GP number and CH number.
Note
: If microphone LCD shows "LO", it means battery power will be exhausted.
Please exchange new battery. In the meanwhile, microphone will still work
normally for about 3 minutes. After 3 minutes if battery is not replaced,
microphone will stop working.
8. Take out battery if microphone is not going to be used for a long period of time.
9. Battery installation.
A. Turn battery bottom cover 90 degree anti-clockwise to "OPEN" position (figure 1),
press "push" button to spring out battery compartment a little, pull out the battery
compartment and install or exchange battery.
B. Insert 9V battery(pay attention to the positive and negative pole) and then push
the battery compartment back (figure 2). Turn battery cover 90 degree clockwise
to "LOCK" position (figure 3).
1. Open battery cover(8), insert attached 9V battery into battery compartment and
then close battery cover.
2. Turn on power switch (7), LCD will show group and channel set at last using time.
3. Group adjust: Press GP button (5) for about 3 seconds, GP number on LCD will
flash; release GP button (5), now GP button changes to UP function and CH button
changes to DOWN function, press GP button to move GP UP or CH button to move
GP down.
