15
promesstec GmbH
I Niedersachsenstraße 4 I D- 48465 Schüttorf I Tel.:+49 (0)5923/ 90 229 0 I Fax:+49 (0)5923/ 90 229 29
E-Mail: [email protected] I Internet: www.promesstec.com
10.6 Control of the device
The devices are checked before shipment and sent in perfect condition. If damage
is visible on the device, we recommend a thorough inspection of the transport pack-
aging. In the event of damage, please inform the supplier immediately.
11. Installation
The device may only be connected by technicians who are familiar with and follow
the technical terms, warnings and instructions in the manual.
If you have any doubts about the correct handling of the device, you should contact
promesstec GmbH directly.
The installation and connection of the device must be carried out in accordance with
the applicable regulations of the respective country regarding the installation of elec-
trical equipment, including cable cross-section, (electrical) pre-fusing and positioning.
A description of input/output and supply connections is given on the block diagram
and on the side label.
The following applies to devices that are permanently connected to a dangerous volt-
age: The maximum size of the back-up fuse is 10A and must be easily accessible
and close to the unit, along with a circuit breaker. The circuit breaker should be
marked in such a way that there can be no doubt that it cuts power to the equipment.
12. Order code
Order code: UMU-FD 2
Order example: UMU-FD 2
