Contents
7.
Description of the drive system
7.1 - 7.6
7.1
Basic motor (QD55x, QE55x)
7.1.1
Procedure for checking and adjusting the clutch clearance
7.1.2
Procedure for replacing of clutch
7.1.3
Procedure for replacing the clutch and brake disk
7.2
Control system - control box
7.3
Speed control unit (command unit)
7.4
Synchronizer (position control unit)
7.5
Operator's control panel OC-TOP
8.
Application
8.1 - 8.3
8.1
Sewing without an operator's control panel
8.2
Sewing with operator's control panel B2
8.3
Sewing with external operator's control panel OC-TOP
8.4
Error messages (malfunction diagnostics)
9.
Programming by the user
9.1 - 9.6
9.1
User programming with operator panel OC-TOP
9.1.1
Programming level A (operator level)
9.1.2
Programming level B (technician level)
9.1.3
Programming level C (special level)
9.1.4
Reset
9.2
User programming without operator panel
9.2.1
Needle positions NPx
9.2.2
Maximum speed (<607>)
9.2.3
Standstill brake (residual brake <718>)
9.2.4
Reset
10.
Start of operation
10.1 - 10.9
10.1
Start of the operation without the operator's control panel
10.1.1
Procedure for checking the direction of rotation and for the correct
adjustment of the needle bar
10.1.2
Control of the needle positions (NP1 / NP2)
10.1.3
Control of the positioning (angle) for thread trimming (NP5 / NP6)
10.2
Start of the operation with operator's control panel OC-TOP
10.2.1
Procedure for checking the direction of rotation and for the correct
adjustment of the needle bar
10.2.2
Control of the needle positions (NP1 / NP2 / NP3)
10.2.3
Control of the positioning (angle) for thread trimming (NP5 / NP6)
10.3
Procedure for checking the maximum speed
10.4
Hardware test
P20K2TI-2E
111296
Technical updatings reserved!
www.promelectroavtomat.ru
