Promax NGM EVO, Руководство пользователя

Страница: 21 / 32

21
NGM EVO USER GUIDE
5 Pro gram min g
5.1 Manual Boot
The board usually uses an automatic boot.
In case, the automatic boot is not available, it is necessary to proceed in the following way:
1) Run the program NGPROG (if used VTB skip step 2 and 3)
2) Set the COM and the type of card NGMEVO
3) Load the application. SREC and press TRANSFER APPLICATION
4) Press the keys simultaneously within 15 seconds RESET AND BOOT on the board
5) Release the RESET button
5.2 Upload VTB application
For upload VTB application, is possible use the following mode:
The board NGMEVO is automatically in BOOT MODE (if is not available, see 5.1) when you use the BUTTON
UPLOAD APPLICATION. The application is automatically RUN when the transfer is finish.
5.3 NGPROG
The application was developed by Promax NGPROG to allow the update software and firmware of the new
controls based on μP ColdFire.
5.3.1 Upload firmware
1) Press button “FIRMWARE MANAGEMENT” on NGProg
2) If you use “UPDATE da File” use the standard windows Browser for find the .SREC file
2) If you use “UPDATE da Server” you must have a intenet active connection, NGPROG
search in Promax server the new version of firmware
3) Select the serial port to PC and NGMEVO (or NGM13 if not present) board type
4) Start the upload firmware
5.3.2 Upload VTB application
1) Select the NGMEVO (or NGM13 if not present) Board
2) Select the COM on PC
3) Selct the .SREC file by button “LOAD”
4) Start the upload by button “Upload Application”
6 Statu s Led
ST-1/L1 (Green led):

Fast blink – board in BOOT MODE

blink1 sec – application RUN
ST-2/L2 (Yellow led):

NO BLINK - No activity on RS232 or CAN SLAVE

BLINK - activity on RS232 or CAN SLAVE
PWR (Red led): Power On