Promaker PRO-SD480, Руководство пользователя

Страница: 9 / 32

9
ASSEMBLY AND OPERATING
CHARGING THE BATTERY
1. Place the cordless
screwdriver near a 120 V, 60 Hz
electrical outlet.
2. Insert the battery charger
plug (1) into the charger receptacle
(2) In the handle of the cordless
screwdriver (3) (Fig. 1).
3. Plug the battery charger (4)
into a 120 V 60 Hz wall receptacle.
NOTES:
a)
The red indicator light (5) in
the handle will turn ON, indicating a
positive connection with the charger.
b)
The red indicator light will
remain ON until the charger is
disconnected.
c)
A new battery or one that
is completely run down should be
charged for 5 hours. After normal
use, a battery should be fully
charged in about 3 hours or more.
d)
If the battery does not charge
properly, check to make sure the
electrical outlet is “live” and that the
temperature range in the work area
is between 10^t0°C (50-104°F).
INSTALLING SCREWDRIVER
BITS
Fig.1
Never hold the body of the
cordless screwdriver near the
switch while changing
screwdriver bits. Accidentally
touching the switch may start the
tool and possibly cause an injury.
1. Select an appropriate
screwdriver bit that fits the head of
the screw being driven.
NOTES:
a) Use the largest size
screwdriver bit that will properly fit
the screw head.
b) Make sure the screwdriver
bit is in good condition and is neither
damaged nor worn.
2. Insert the screwdriver bit (1)
fully into the screwdriver collet (2)
(Fig. 2).
NOTE: Make sure the screwdriver
bit is fully inserted into the collet.