Promac SY-350V, Руководство по эксплуатации

Страница: 13 / 77

9. The operation cycle
Before operating all the main parts of the machine must
be set to optimum conditions (see the chapter on
“regulating the machine”)
Use the miter lock lever (A) to release the disk head
assembly.
Rotate the disk head assembly to the correct miter angle
Check the miter angle on the angle indicator (B) below
the vise
Use the miter lock lever (A) to lock in the miter angle.
9.1 Vice operation
The quick clamp vise lever allows the operator to quickly
clamp and unclamp work-pieces of same width. This
allows for efficient use of machine for loading and feeding
forward work-pieces.
Use the hand wheel to open and close the vise jaw for work
pieces that vary in width
- Rotate the hand-wheel (A) counter-clockwise to open the
vise.
- Rotate the hand-wheel (A) clockwise to close and approach
the vise jaw (C) to the work pieces.
Use the vise lever to quickly clamp and unclamp work pieces
of the same width.
- Rotate the vise lever (B) clockwise to clamp the work-piece.
- Rotate the vise lever (B) counter-clockwise to unclamp the
work-piece.
The clamping vise set equips with the function to adjust
forward and backward for extending the clamp capacity.
There is a sliding devise between the swing base and the
bottom of the vise. Please refer to the indicator on picture
(9.1 D).
- Pull out the vise set that the entire vise ti come out and vice
versa.
The clamping vise equips with another function for making
the slot cutting in the head was set in 90 degree.
Take off the set of bar stop of setting cutting measurement.
Use a hex wrench 5mm to loss the M6x10 screw on the long
rod (Q-6.3 pic.-9 ).
- Loosen the miter lock lever (9.1 A).
- Rotate the entire dick head unit to the right, checking the
angle on the indicator (9.1, B) at the 90 degree of vise.
- Upload the material and clamp it securely before cutting.
13