Promac 348C, Инструкция по эксплуатации

Страница: 18 / 32

Use
Before use
Make sure the blade is not in contact with the part when the motor is started.
Run the motor and let the saw reach full speed. Start the cut by bringing the head down slowly over the part.
DO NOT LOWER THE HEAD BACK DOWN AND DO NOT FORCE IT. Allow the weight of the saw to make
the effort required for the cutting. The saw will automatically stop at the end of the cut.
Feed rate
The feed rate is pre-set (mark H) in the factory for full
metal cutting.
To reduce the feed rate, proceed as follows:
1. Release the locking pin by gently pulling on button
(A) of Fig. 3.
2. Turn wheel (B) towards the button and stop at mark
M. Let the locking pin slide into the groove. The
feed rate is adjusted for cutting thicker metal tubing.
3. Turn the wheel, stop at mark L and lock it at this
position. The feed rate is adjusted for cutting thinner
metal tubing.
Oblique cut
The machine uses a pivoting mitre block for oblique cuts
from 0 to 45 degrees. The pivot arm has an an index -
(A) in Fig. 4. The machine is pre-set to zero degrees
when it leaves the factory. An oblique cut is adjusted in
the following way:
1. Loosen bolt (B) to release the arm.
2. Move the pivot arm forwards along the scale to find
the angle that best fits the part to be cut.
3. If the index corresponds to the appropriate
gradation of degrees on the the scale, tighten the
bolt. This will ensure cutting at the perfect angle.
Fig. 3
Fig. 4
Direction of travel of the blade
Make sure that the blade is mounted on the wheels in such a way that the vertical cutting edge engages first
with the part.
BEFORE STARTING THE SAW
DO NOT FORGET TO DETACH THE LOCKING TAB BETWEEN THE ARM OF THE SAW AND THE SAW
BENCH TO RELEASE THE SAW. AFTER USE DO NOT FORGET TO REPLACE IT TO PERMIT EASY
AND SAFE TRANSPORTATION OF THE MACHINE.
18