- 10 -
n
HOW TO CLEAN AND REPLACE THE FILTER(s)
When the Filter is dirty and the suction power is reduced, you must clean or replace the filter.
Clean and replace the filter:
1.
Open the bag chamber by releasing the latches located on the sides of the machine.
2. Pull the filter from the top of the bag chamber by simply lifting it straight up and out.
3. Clean the filter using warm water then allow the filter to air dry completely, OR by lightly tapping it against the
inside of your garbage receptacle to knock the debris off that has built up on the filter. Once this has been done,
then assemble the filter back into the top of the bag chamber. Or, if the filter is too dirty or in an unusable
condition, replace the filter with a new one.
n
CLEANING THE HOUSING
WARNING
: Always switch off the appliance and disconnect it from the outlet before cleaning it.
ATTENTION
: Do not use Alcohol, cleaning or scouring agents to clean your machine, as these may damage the
appliance. Clean the outside of the housing using only a slightly damp washcloth.
Troubleshooting
WARNING
: Never use a defective appliance. Always switch off the appliance and disconnect it from the outlet before
you start to troubleshoot.
Fault
Possible Cause(s)
Solution
The vacuum will not turn on.
The plug is not connected to the
electrical wall outlet or the
appliance is not switched to the
“on” position.
Insert the plug into an electrical
wall outlet and flip the “on/off”
switch to the “on” position. See
page 9.
Electrical wall socket does not
carry current.
Test the vacuum cleaner on another
outlet that you are sure is carrying
current.
The power cord is damaged.
Replace with a new cord by an
authorized service center or
professional technician.
Suction power is low.
The bag chamber or bag is full or
clogged.
Empty the chamber/replace the
bag.
One of the attachments, wand or
suction hose is clogged.
Remove the debris that is causing
the clog. If necessary, use a long
wooden stick (e.g. a broomstick) or
coat hanger to do this.
The bag chamber is installed
incorrectly.
Remove the bag chamber and
reinstall; making sure the container
is locked into place correctly when
reinstalling.
Содержание XC15J
Страница 6: ...6...