7
Reversing The Door
Reversing the door may make installation more convenient. The appliance
must be tilted backwards and supported in order to carry this out; it is therefore
advisable to get an assistant to help during this procedure. Take care when
fitting and tightening screws.
1. Remove the hinge cover, screws, upper hinge and washer(FIGURE 1);
2. Lift the door off the lower hinge pin and place it on a padded surface to
prevent scratching it.
3. Tilt and support the appliance. Unscrew the lower hinge screws and
remove the lower hinge(FIGURE 2).
4. Remove the left-hand fixed foot and transfer it to the right-hand
side(FIGURE 3).
5. Re-fit the lower hinge to left-hand side of the cabinet.
6. Return the appliance to the vertical position and re-fit the door on the lower
hinge pin, aligning it(in the closed position) with the cavity opening.
7. Remove the blanking caps which cover the left-hand screw holes on the top
of the cabinet and re-fit them to the holes on the right-hand side of the
cabinet.
8. Re-fit the upper hinge to the left top of the cabinet, then adjust upper and
lower hinges as required. Make sure the door gasket makes contact with
the cabinet body all the way around the cavity opening.
9. Re-fit the upper hinge cover. If necessary, level the unit using the
adjustable front foot.
UPPER HINGE
FIGURE 1
FIGURE 2
FIGURE 3
HINGE PIN
FIXED FOOT
