Z700SPOT
8
-
2
- INSTALLATION
2
.1 LAMP
We recommend using MSRGold Philips 700W Fastfit (cod. 800188). Make sure that the used lamp is compat-
ible with local voltage. If the lamp is operated with a voltage surpassing its nominal operating voltage, it can
be damaged or its service life reduced considerably.
2
.
2
INSERTING OR REPLACING THE LAMP
Please proceed as follows to replace the lamp (the lamp gets very hot during operation, so let it cool down
sufficiently before you attempt to dismount it! Lamps that have been damaged must be replaced immedi-
ately).
1. Disconnect the power plug the unit, Unscrew the two screws X and Y, open the lamp cover, turn it to the
position as the diagram shown.
2. Hold the base of the lamp, anticlockwise turn until it is parallel to the groove.
3. Do not touch the lamp’s envelope with bare hands. Should this happen, clean the bulb with a cloth
soaked in alcohol and dry it with a clean, dry cloth. Insert a new lamp follow the groove, turn it clockwise
to fix the lamp.
4. Screw the screws X and Y to fix the lamp cover.
5. Turn the screws (A, B and C) to adjust the lamp position, be sure it is located in the center of the reflector
for the best projection.
Fig.3
Lam p bas e
Lam p cove r
Содержание Zenith 700SPOT
