ProLights TRIBE LUMIPIX12UT, Руководство пользователя

Страница: 32 / 44

LUMIPIX12UT 10
3.7 MANUAL COLOR
This mode allows to combine the colors red, green, blue amber white and purple (r, g, b) .
• Press the button MENU so many times until the display shows [U--] , then press the button ENTER.
• Select the color r, g, b through the buttons UP/DOWN.
• Press the button ENTER to confirm.
• Using UP/DOWN button, select the desired color value
000 - 255
.
• Press ENTER button to continue to the next color.
• Continue until the desired mix is obtained.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.8 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave.
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 13).
• Use any one of the standalone modes for the master unit.
• Set the slaves to the same DMX modes.
3.9 LINKING
1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
3.10 DMX MODE
• Press the button MENU so many times until shows, 3 CH, 4CH, 6CH, 7CH, 8CH, 9 CH, 12 CH, 18 CH, 36CH o 41 CH and
press the button ENTER to confirm.
• Press the button UP/DOWN to select the desired DMX address d1 - d512 . Press and hold to scroll quickly.
Press ENTER button to store.
The tables on page 14 indicate the operating mode and DMX value. The LUMIPIX12UT is equipped with 3
pole XLR connections.
3.11 DMX ADDRESSING
To able to operate the LUMIPIX12UT with a light controller, adjust the DMX start address for the first a DMX
channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX chan-
nel, adjust the start address 33 on the LUMIPIX12UT. The other functions of the light effect panel are then
automatically assigned to the following addresses.
An example with the start address 33 is shown below:
Number of
DMX channels
Start address
(example)
DMX Address
occupied
Next possible start
address for unit No. 1
Next possible start
address for unit No. 2
Next possible start
address for unit No. 3
6 33 33-38 39 45 51
9 33 33-41 42 51 60
12 33 33-44 45 57 69