ProLights SMARTTUBE32, Руководство пользователя

Страница: 31 / 40

11
SMARTTUbE32
Manual Color Control
To choose a specific color with the controller:
1. Press MANUAL on the controller.
2. Press any number between 0-9 to choose your color.
To manually control the RGB percentage:
3. Press MANUAL on the controller.
4. Press R, G, or B to choose your color.
5. Press + or – to increase or decrease the percentage of each color.
Miscellaneous Operation
To adjust the strobe rate of the program:
1. Press STROBE on the controller.
2. Press + or – to increase or decrease the strobe rate.
3. Press STROBE again to turn off the strobe.
To change the switching effect of the program:
• Press FADE/SNAP on the controller.
• Fade will slowly switch the effect. Snap will rapidly switch the effect.
To black out the lights:
• Press BLACK OUT on the controller.
• This will turn off all the lights until the button is pressed again.
NOTE - The controller will not respond to any inputs when Black Out is activated. If the remote does not
respond when a button is pressed, try pressing BLACK OUT. You may have inadvertently activated BLACK
OUT.
3.12 MASTER/SLAVE MODE WITH WIRELESS SIGNAL
This mode allows you to wirelessly connect more units SMARTTUBE32, without a controller. The first unit,
transmitter signal, it will be set as master and the others, receivers, as slave.
Wireless communication between devices can be configured in two ways:
Manual transmit/receive mode
On Master unit:
• Press the MENU button so many times until the display shows S-tr .
• Press the ENTER button to confirm.
• Press the UP/DOWN button and select dtCH .
• Press the ENTER button to confirm.
• Press the UP/DOWN button, select one of the transmitting signal dt 1 - dt 16 .
• Press the ENTER button for save the setting.
• Note: Use any one of the standalone modes for the master unit.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
• Note: Use any one of the standalone modes (AUTOSHOW or STATIC COLOR) for the master unit.
On Slave unit:
• Press the MENU button so many times until the display shows S-tr.
• Press the ENTER button to confirm.
• Press the UP/DOWN button and select drCH
• Press the ENTER button to confirm.
• Press the UP/DOWN button, select one of the transmitting signal dr 1 - dr 16
• Press the ENTER button for save the setting.
• Press the button MENU so many times until shows, 3CH - 8CH - 48CH or 50CH and press the button ENTER
to confirm.