ProLights SK2008, Руководство пользователя

Страница: 12 / 16

SK2008
4
- 3 - FUNCTIONS AND SETTINGS
3.1 Operation
Note that fog machines develop condensation around the output nozzle. This may result in moisture ac -
cumulation on the surface below the output nozzle. Consider this condensation when installing the unit.
All fog machines may sputter small amounts of fog occasionally during operation and for a minute or so
after being turned off. The LED lights upon the fog machine being plugged in properly. After few minutes
of warm-up time, the fog machine will be in “ready to fog” condition.
Note: The LED on the bottom of the tank indicates the fog fluid level; when flash , the fluid level is low and
requires refill, the pump stops simultaneously. Simply refill the tank, the pump will function again.
ADD PROLIGHTS FLUID IN TIME IF THE SMOKE MACHINE KEEPS RUNNING WHEN IT HAS RUN OUT OF
FLUID. ITS PUMP WILL BE DAMAGED
Place the unit on a horizontal surface;
- Unscrew the tank cap.
- Fill up the fog fluid container (SMOKEFLUID series). If any fluid is spilt, wipe it off immediately with a dry
cloth. It must not get inside the unit.
- Tightly close the tank. Make sure that the suction hose will reach the bottom of the tank.
- Firmly attach the remote control mechanism SKC10 to the socket.
- Plug main power cord from the fog machine into the appropriate power supply socket. Wait a few min -
utes for heating element to heat up.
- When the heating process is completed the fog machine is ready for use.
- If fog is emitted continuously for a long time, the heating element temperature may drop, shutting off
fog production. If so, please do not activate fog emission. Wait briefly. When the heating element tem -
perature rises, fog emissions can be resumed.
Warning. While filling up the fog fluid container (SMOKEFLUID series), the unit must not be connected. Dis -
connect the main plug from the socket first!
The unit is not splashproof. If fluid accidentally gets inside the unit, do not set the fog machine into opera -
tion; it must be cleaned and checked by skilled personnel first.
3.2 Troubleshooting
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps. If the problem persists, refer servicing to a qualified technician.
Power connected but no fog is emitted:
1. Check the power supply. Plug the unit into grounded electric power supply socket with proper voltage.
2. Check your controller connection or controller receiver connection. Fulfill controller usage requirements
for distance, etc. Follow procedures listed in controller manual.
3. Disconnect fog machine from electric power supply. Replace fuse with one of the same type.