ProLights PHYRO500, Руководство пользователя

Страница: 18 / 24

PHYRO500
6
- 2 - FUNCTIONS AND SETTINGS
2.1 BASIC
1. Remove all packing materials from shipping box. Check that all foam and plastic padding is removed,
especially in the nozzle area.
2. Place fog machine on a flat surface and remove fog liquid tank cap.
3. Pour the Prolights liquid in the tank without exceeding the maximum level to prevent overflow. Col-
lect immediately with a dry cloth to prevent that any liquid enters into the machine. The unit is not
protected against splashing water. If liquid does get inside, do not operate the machine, but refer for a
control, to the nearest authorized service center.
4. The machine only works with Prolights liquid SMOKEFLUID series. Any other types of fluid can damage
the unit. During the filling operation, the machine must not be connected to the electricity grid. First
disconnect the plug from the socket.
5. Always replace the tank. Check that the suction hose reaches the bottom of the tank.
AVOID THE UNIT REMAINS WITHOUT THE FOG LIQUID: THE PUMP COULD BE DAMAGED.
NOTE
• All fog machines develop condensation around the output nozzle. Because this may result in some
moisture accumulation on the surface below the output nozzle, consider this condensation when in-
stalling your unit.
• All fog machines may sputter small amounts of fog occasionally during operation and for a minute or
so after being turned off.
• All fog machines have a recycling period after long bursts when the machine will shut itself down for a
short period in order to heat up again. During this time no fog can be produced.
2.2 OPERATION
1. Add fluid carefully to the liquid tank. Do not overfill the tank.
2. Plug power cord into a grounded electrical outlet. Turn the power switch to “ON” on the back of the
machine. The unit will start to warm-up the machine. Wait a few minutes for heating element to heat
up. During this time the machine cannot generate any fog. When the warm-up process is complete the
green light will stay ON.
3. Please now refer below of instructions of Remote Controller for setting for the remote controller com-
mand.
Important:
• Always monitor tank fluid level as you are fogging.
• Never drink Fog liquid. If it is ingested, call a doctor immediately. If fog liquid comes in contact with skin
or eyes, rinse thoroughly with water.
• Always replace the caps on the fog liquid container immediately after filling to avoid contamination.
NOTE - If you experience low output, pump noise or no output at all, unplug immediately. Check fluid
level, the external fuse, and power from the wall. If all of the above appears to be O.K., plug the unit again.
If fog does not come out after holding the remote button down for 30 seconds, check the hose attached
to the tank to make sure there is fluid going through the hose.
If you are unable to determine the cause of the problem, do not simply continue pushing the remote but-
ton, as this may damage the unit. Return the machine to your dealer.