ProLights ICEMACHINE, Руководство пользователя

Страница: 13 / 20

5
ICEMACHINE
• Press the switch again TIMER (1) to disable the timer function. The yellow LED turns off.
• Press the red switch once Conte (2) to have a steady stream of smoke. Adjust the volume with the volume
knob (5). This function has priority over the timer function, whose settings are ignored.
• Press again Conte (2) to end the issue.
• The green button manual (3) has priority over all other functions. When pressed, causing the emission of
smoke at full volume. This allows full manual control of the interval and duration of the release.
Function Instruction
1
TIMERS ON/OFF
Pressing the button, the LED lights yellow, indicating the deactivation of the Timer control.
2
CONT
Press the button, the LED lit red, indicating the state of continuous emission of smoke.
3
MANUAL
A lit green indicates that the heating process is complete and the unit is ready to operate.
4
INTERVAL
9 s - 280 s ± 10%
5
VOLUME
0% - 100%
1. TIMERS button;
2. CONT button;
3. MANUAL button;
4. INTERVAL button;
5. VOLUME button;
Fig.1
4
1
2
3
5
2.3 DMX control
The ICEMACHINE is characterized by one control channel DMX. On the rear panel of the machine you can
find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can be used for connecting a DMX controller
or several devices. Set the DMX address by turning on the switches on rear panel. The machine uses just
one DMX channel for work. The value of the DMX address is the sum of the switches setted on ON position.
The DMX values for each switch is:
n.1 = valore DMX 1 n.2 = valore DMX 2 n.3 = valore DMX 4
n.4 = valore DMX 8 n.5 = valore DMX 16 n.6 = valore DMX 32
n.7 = valore DMX 64 n.8 = valore DMX 128 n.9 = valore DMX 256
2.4 Troubleshooting
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps. If the problem persists, refer servicing to a qualified technician.
Power connected but no fog is emitted:
1. Check the power supply. Plug the unit into grounded electric power supply socket with proper voltage.
2. Check your controller connection or controller receiver connection. Fulfil controller usage requirements
for distance, etc. Follow procedures listed in controller manual.
3. Check setup DMX.
4. Disconnect fog machine from electric power supply. Replace fuse with one of the same type.