GHOST GH100F
6
- 2 - FUNCTIONS AND SETTINGS
2.1 OPERATION
Note that Fazer machines develop condensation around the output nozzle. This may result in moisture ac-
cumulation on the surface below the output nozzle. Consider this condensation when installing the unit.
All fazer machines may sputter small amounts of fog occasionally during operation and for a minute or
so after being turned off. The unit has a power switch; to operate connecting the unit to supply and turn
the power switch to ON. The machine will immediately start heating up and in the standby mode, during
this time the LCD pannel will display “ WARMING UP”. It requires few minutes for heating element to heat
up. When the machine is ready during the warming up session, the LCD display will change to “READY TO
FAZER
ADD PROLIGHTS FLUID IN TIME IF THE SMOKE MACHINE KEEPS RUNNING WHEN IT HAS RUN OUT OF
FLUID. ITS PUMP WILL BE DAMAGED!
Place the unit on a horizontal surface;
•
Unscrew the tank cap.
•
Fill up the fog fluid Prolights container. If any fluid is spilt, wipe it off immediately with a dry cloth. It
must not get inside the unit.
•
Make sure the fluid level does not exceed the indicator outside the housing.
•
Tightly close the tank. Plug main power cord from the fog machine into the appropriate power supply
socket and set the power switch to “ON” (11). Wait a few minutes for heating element to heat up.
WARNING - while filling up the water-fluid container, the unit must not be connected. Disconnect the main
plug from the socket first!
The unit is not splashproof. If fluid accidentally gets inside the unit, do not set the haze machine into op-
eration; it must be cleaned and checked by skilled personnel first.
2.2 BASIC
The fazer machine GHOST GH100F has a LCD display and 6 button used to access the control panel func-
tions and manage them (fig.2).
FUNCTION
TIMER
VOLUME
MANUAL
Fig.2
