ProLights Fury FY400S, Руководство пользователя

Страница: 35 / 52

11
FURY FY400S
3.4 OPERATION IN AUTOMATIC MODE
If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
• Press the button MODE/ESC to access the different modes [NASI, NAFA, NStS, SLAv] .
• Press the button UP/DOWN to switch between the programs [NASI] (slow) o [NAFA] (fast). Press the ENTER
button to confirm. The unit will operate in automatic mode by executing, respectively, in fasto or slow
the program pre-set.
• Press the button MODE/ESC to go back or wait a few seconds to exit the setup menu.
NOTE - In automatic mode the unit will be set as Master.
3.5 OPERATION IN SOUND MODE
• Press the button MODE/ESC to access the different modes [NASI, NAFA, NStS, SLAv] .
• Press the button UP/DOWN to select mode [NStS]. Press the ENTER button to confirm.
• Press the button MODE/ESC to go back or wait a few seconds to exit the setup menu.
3.6 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
• Press the button MODE/ESC to access the different modes
[NASI, NAFA, NStS, SLAv]
.
• Press the button UP/DOWN to select mode [SLAv] Press the ENTER button to confirm.
• Set to DMX address to 001
• Select the desired operation mode (see section 3.4)
• Press the button MODE/ESC to go back or wait a few seconds to exit the setup menu.
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 13).
3.7 LINKING
Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
3.8 DMX CONFIGURATION
The FURY FY400S is equipped with 2 DMX configuration.
• Press the button MODE/ESC to scroll the main menu, until appears [14CH] / [8CH] .
• Press the button UP/DOWN to select mode
[8CH]
(8 channels) or
[14CH]
(14 channels). Press the ENTER
button to confirm.
• Press the button MODE/ESC to go back or wait a few seconds to exit the setup menu.
The tables on page 14 indicate the operating mode and DMX value. The FURY FY400S is equipped
with 3-pole XLR connections.