ProLights EVO392FL, Руководство пользователя

Страница: 27 / 40

9
EVO 392FL
3.5 SPECIAL FUNCTIONS
• Press the button MENU and select through the directional buttons the [SET] mode; and press the button
ENTER to confirm.
It is possible to view to following functions:
KEY
• Enter the [KEY] mode to select whether the access password is on or off.
• Select [ON] or [OFF].
When the fixture is set as pass
[ON],
after 30 seconds or turn on the fixture next time, the fixture will
need an access password to enter the display menu control.
NOTE - The factory access password is UP + DOWN + UP + DOWN. Press ENTER to confirm the access.
DIM
Enter to [DIM] to select specific dimming curve. When dimmer is set to [OFF] , the dimmer is linear.
DIM1/2/3/4 are speed modes of the linear dimmer; [DIM1] is the faster, while [DIM4] is the slowest.
CALE
Enter the [CALE] mode to enable or disable the calibration.
• Select [ON] or [OFF].
CAL1
Enter the [CAL1] mode to set the calibration of color temperature.
• Through the button UP/DOWN, select the desired color
[C.255]
or
[W.255]
then press ENTER to con-
firm.
• Using UP/DOWN, select the desire color value [C.000 - 255], [W.000 - 255].
• Press the button ENTER to save setting.
REST
In order to reset custom modes to default values select [REST] .
NOTE - The factory access password is UP + DOWN + UP + DOWN. Press ENTER to confirm the access.
SLCK
• In this function [SLCK] you can enable or disable the password to access the settings menu.
• Select
[ON]
or
[OFF].
When the fixture is set as pass [ON], after 30 seconds or turn on the fixture next time, the fixture will
need an access password to enter in settings menu.
NOTE - The factory access password is UP + DOWN + UP + DOWN. Press ENTER to confirm the access.
3.6 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
• Press the button MENU so many times until the display shows [RUN] and press the button ENTER.
• Press UP/DOWN to set the unit as slave
[SLAVE]
.
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 11).