ECLFC
12
3.4 STATIC MODE
This fixture has the ability to accept custom static color settings. Access these chases via the control panel
on the back of the fixture.
• Press the button MENU so many times until the display shows
STATIC
, then press the button ENTER.
• Select
Fixed Color
through the buttons UP/DOWN, then press the button ENTER.
• Set the colors
Red, Green, Blue, Lime, Red Green, Red Blue, Red Lime, Green Blue, Green Lime, Red Green Blue, Red
Green Lime, Red Blue Lime, Green Blue Lime, Red Green Blue Lime
, through the buttons UP/DOWN, then press
the button ENTER.
• Select
Color Temperature
through the buttons UP/DOWN, then press the button ENTER.
• Set the color temperature
White 2700K, White 3200K, White 4200K, White 5000K, White 5500K, White 6000K, White
7000K, White 8000K, White 9000K, White 10000K
, through the buttons UP/DOWN, then press the button EN-
TER.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.5 MANUAL MODE
This mode allows to combine the colors red, green, blue and lime.
• Press the button MENU so many times until the display shows
STATIC
, then press the ENTER button.
• Select
STATIC
, and next select
Manual Color Mixer
through the buttons UP/DOWN, then press the ENTER
button.
• Select the color
Red, Green, Blue, Lime
through the buttons UP/DOWN, then press the ENTER button.
• Using UP/DOWN button, select the desired color value
000 - 255
.
• Press ENTER button to continue to the next color
Red, Green, Blue, Lime
.
• Continue until the desired mix is obtained.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.6 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
• Press the button MENU so many times until the display shows
STAND ALONE
and press the ENTER button.
• Press UP/DOWN to set the unit as master or slave
(MASTER, SLAVE)
.
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 15).
3.7 FULL ON MODE
• Press the MENU button until
FULL ON MODE
appears on the display, then press the ENTER button.
• Select the desired mode:
HB
(High Brightness mode, with maximum color value) or
Studio
, with an au-
tomatic white balance.
• Press the ENTER key to confirm.
• Press the MENU button to go back or wait a few seconds to exit the setup menu.
3.8 WHITE BALANCE MODE
• To set the white balance, press the MENU button until
WHITE BALANCE
appears on the display, then press
the ENTER button.
• Use the UP / DOWN keys to select the color:
Red, Gree, Blue, Lime.
Press ENTER to confirm.
• Use the UP / DOWN keys to set the desired value 125-255.
• Press the ENTER key to continue and go to the next color
Red, Gree, Blue or Lime
.