ProLights DTD no. 521-7135, Руководство пользователя

Страница: 31 / 44

9
DIAMOND152
- 3 - FUNCTIONS AND SETTINGS
3.1 Operation
Connect the supplied main cable to a socket (230 V~/50 Hz). Switch on the DIAMOND152 with the mains
switch (13). The red LED POWER (4) lights up as a power indication. To switch on the laser beam, connect the
supplied key to the lock of the switch (17) and turn the key to position ON.
When laser is powered on, the LED monitor on rear panel shows the current operating mode.
Then the unit is ready for operation and can be operated via a DMX controller or it independently performs
its show program in succession.
WARNING! This laser corresponds to the class 3B. Do not permit operation by persons not qualified for op-
erating the device.
Laser will be output from laser aperture in 5 seconds after the unit is powered on.
• Regular breaks during operation are essential to maximize the life of this device as it is not designed for
continual use.
• Do not switch the unit on and off in short time intervals.
• Always unplug the unit when it is not used for a longer time.
• In the event of serious operation problems, stop using the fixture and contact the manufacturer directly.
3.2 Basic
Access control panel functions using the four panel buttons located directly underneath the LED Display
(fig.4).
Fig.4
[FUNC]
[ENTER]
[UP]
[DOWN]
to choose the operating mode of laser.
to confirm all setting or change of LED control panel.
to change operating mode, parameter or DMX address.