LEDJ RAINBOW TUBE CONTROLLER
INTRODUCTION
Your Rainbow Tube Controller carton should contain the following:
1. The Controller itself
2. A 12V DC power supply
3. A mains cable with a 13A plug on one end and a 3 pin round plug on the other end.
Introduction
This Dedicated controller will allow you to control your Rainbow Tubes. You can choose one of
the internal programs, or when used with a DMX controller you can create your own
programmes.
Connecting the Tubes to the Controller
1. Using the mains cable supplied, connect the first tube, then continue to link via the 3-pin
connectors from one tube to the next up to a maximum of 60 tubes. If you wish to use more
than 60 tubes then you will require another mains cable to power the next 60 tubes and so
on.
2. Plug the 4 pin round socket (that is connected to your controller by a short lead) into the 4 pin
plug on your first Rainbow Tube, then continue to link all your tubes together in series.
3. Plug the 12V power supply into the socket on the back of the controller
4. You can now power up your tubes and controller.
5. Press the SET UP button, and the LCD screen will read “Tube: 0000”. You have to set the
number of Rainbow Tubes that you have connected to the dedicated controller. Press the UP
or DOWN buttons to select the quantity of tubes. Press the MODE button to go to the
programme mode.
6. Press the MODE button to go through the different programmes.
7. To adjust the interval, and speed time and flash rate of a programme, choose your
programme and press the SET UP button.
Note: Programmes 1 – 5 and 30 do not have adjustable features.
