ProKlima 24960043, Инструкция по эксплуатации

Страница: 90 / 216

- 89 -
3) Sleeping: Touch button “ ” to choose the sleeping mode. LED light of “ ” will be on. And then
touch button “ ” to choose your desired wind speed as follows.
a. : 30 minutes high natural wind → 30 minutes medium natural wind → continuous low
natural wind
b. : 30 minutes medium natural wind → continuous low natural wind
c. : Continuous low natural wind
4) ECO: Touch button “ ” to choose ECO mode. LED light of “ ” will be on. Under this mode,
when the ambient temperature is below 25
℃
the appliance will work at low speed; when the
ambient temperature is above 29
℃
the appliance will work at high speed; when the ambient
temperature is between 25
℃
~29
℃
the appliance will work at medium speed. (The speed button
“ ” will not work under this mode.)
7. After use, touch button “ ” to turn off the appliance and unplug it.
FUNCTION CONSERVATION
The operation function will be conserved before shut down and the fan will work in the same function after
turned on again. (But timer function, wind mode with its speed and oscillation angle detected by body sensor
will not be conserved.)
AUTO DIMMING FUNCTION
The LED lights will dim 30% of original brightness automatically if no operation for above 1 minute. If touch
button again, the lightness will recover.
REMOTE CONTROL
This unit has a remote control. One piece of CR2032 battery is to be installed. The functions of the remote
control buttons are the same as of the touch buttons on the control panel.
Please align the remote control to the remote control receiver on the unit; the remote control will not work if
the receiver is blocked.
Pull out the battery cover shown as below to replace the battery after power off. You can also store the remote
control in the holder on the unit.
CLEANING
1. Before servicing the fan and after each occasion of use, switch off the appliance and unplug the mains
cable from the socket.
2. Never immerse the appliance in water (danger of short-circuit). To clean the appliance, only wipe it
down with a damp cloth and dry it carefully. Always take out the mains plug first.
3. Take care that excessive dust does not build up in the air inlet or air outlet, and clean them every other
month using a banister brush.
4. Do not use any chemical detergent or solvent for cleaning.