5
Instructions for product
Install DC 9V battery to transmitter then
press “ON/OFF” button, it is power on
with a long sound. LCD will showed
“TEST” then auto started wire mapping
test, if the cable is not connected to
transmitter and receiver, the LCD will show “NO ADAPTER”
Cable mapping test
(for example: test RJ45 patch cord)
Plug in RJ45 patch cord to transmitter, and the other terminal into
remote unit, press “ON/OFF” button and push “TEST” button for
wire mapping test. If the cable with shielding (or earthed), LCD will
show “STP”; if not LCD will show “UTP”. Press “LIGHT” to turn on
backlight when you test in dark environment.
Several test results as follows may occur.
Test Result1: Short (SHORT)
If cable or connector connected
situation is short, transmitter LCD will
show “3-4” and “short” with three short
sounds.
Test Result 2: The cable did not plug in remote unit or
transmitter,
LCD will show “NO ADAPTER”:
Test Result 3: Straight
If cable or connector connected situation is good and straight,
LCD will show as following figure with one short sound.
