NOTE: Clean platform elevator (A) and platform (B) using Isopropyl Alcohol. When cleaning
platform, clean the front and back sides.
Ensure that the corner guides (C) on the backside of platform are clean and free of debris. If
debris exists when installing, the platform guides will not lock into the platform elevator.
Lift build chamber door. (See “Familiarization (A)” for build chamber door location. )
Place platform with corner guides and pads
facing down onto the platform elevator
and seat onto elevator
. The magnetic guides will affix the platform to the elevator and if
properly installed, platform will not move. It should sit squarely on the elevator and be firmly
located by the corner guides. Use caution not to drop the platform or hit the printhead.
To remove platform, lift from the sides and pull up and out from the platform elevator .
Close the build chamber door and press ONLINE
.
(E)
(F)
(C)
(D)
(E)
(G)
POWER SUPPLY
PLATFORM INSTALLATION
Before plugging in the power cord,
confirm the specifications of
electrical service and breaker.
Make sure that the red shipping
restraints and braces have been
removed from the printer.
Plug p
Switch power on
Plug
RJ-45 shielded Ethernet cable (not
supplied) into jack .
ower cord
into power outlet
on back side of printer and into facility’s
power outlet.
(A)
(B).
(C)
3D Systems Confidential
NOTE:
A
Ethernet cable is
required when connecting from the
printer to the end user’s computer.
shielded
(C)
The AC voltage and current requirements for the ProJet™ Production Modeling
System are:
·
100 VAC, 50/60 Hz (Dedicated 30 amp. Circuit Breaker)
·
115 VAC, 50/60 Hz (Dedicated 30 amp. Circuit Breaker)
·
230 VAC, 50/60 Hz (Dedicated 20 amp. Circuit Breaker)
Note: The installation of The ProJet™ Production Printing System shall comply
with the National Standards and Local Electrical Codes of the location in
which it is installed.
See ProJet™ Facility Requirement Guide for detailed information for electrical
power supply and other facility information.
WHEN
OPERATING THE PRINTER, ADHERE TO ALL PERSONAL AND SAFE HANDLING OF MATERIALS DESCRIBED IN THE SAFETY SECTIONS OF THE USER GUIDE.
A
ONLINE
G
www.3dsystems.com
B
C
B
B
A
B
E
B
D
C
B
F
B
Quick Reference Guide
3-D Printer
ProJet™ 5000
P.N.: 316131-04, 02/12
