ProJet 5500X, Быстрый старт, Страница: 12 / 15

Open the upper left and upper right MDMs. 1.
Slide both waste drawers completely out of the printer. 2.
Remove waste bags from waste drawers and place into a hazardous waste container. 3.
Replace the plastic waste bag for each drawer. 4.
Close waste drawers and press the Start to resume. 5.
Standby and Conserve Mode
NOTE: If the printer is to be used within 7 to 10 days of the last build, it is
recommended to leave your printer in either standby or conserve mode, instead
of powering off the printer.
If the printer is idle more than 4 hours , it enters Standby mode. If the printer is idle
more than 36 hours , it enters Conserve mode. In these energy-saving states, the
printer heaters are partially cooled and many other components are disabled. It takes
much less time for the printer to warm up from
Standby or Conserve mode than it does
from full shutdown/power off, (see table below). To increase or decrease wait time
before the printer enters
Standby mode or Conserve mode, contact 3D Systems
Technical Support
Mode Time