7
JUMPSTARTER INSTRUCTIONS
Notes: • Instructions for negatively earthed vehicles only. (Most vehicles after 1970
are negatively earthed).
• Before jumpstarting a vehicle make sure that the Jumpstarter is fully charged
JUMPSTARTING
Step
Instruction
Display
1
Your Jumpstarter should be charged for around 8 hours
prior to first use and as soon as possible after each use.
2
Before making any connections, check the Jumpstarter
battery status by turning the Jumpstarter ON. The
Jumpstarter’s battery capacity should be at least 50%
charged (2 bars).
BATTERY STATUS INDICATOR
When Jumpstarter is turned on battery gauge LEDs are displayed.
State of Charge
Battery Gauge LED Display
<20%
– Red flashing
20–25%
– Red
25–50%
– Yellow
50–75%
– Green
75–100%
– Green
3
Before connecting the Jumpstarter’s clamps to the
vehicle turn the vehicle’s ignition to OFF.
4
Connect the Red positive (+) clamp to the positive (+)
terminal of the vehicle battery, then connect the Black
negative (-) clamp to the negative (-) terminal of the
battery or a non-moving metal part of the engine block.
Ensure you have a good clamp connection; this will
guarantee optimal jumpstarting.
DO NOT CONNECT TO FUEL LINE. Always double check
you have proper connections.
5
The “JUMPSTART” button should begin to flash. Press
the “JUMPSTART” button. The clamp LED should turn
on to green.
6
If the “JUMPSTART” button does not flash, it would
indicate the battery is less than 3.0V. The user will need
to press and hold the “JUMPSTART” button for 3 seconds.
The JUMPSTART button will have a double flash. The
clamp LED will now be illuminated and the Jumpstarter is
ready to use. The override will timeout after 60 seconds.
7
Turn the vehicle’s ignition to ON and start the vehicle. After
the engine has started, leave the Jumpstarter connected
for a minimum of 40 seconds to allow the Jumpstarter
to rapidly recover charge from the vehicle’s alternator.
Once the Jumpstarter is fully charged, the Rapid Recharge
Technology (RRT) will shut off and avoid overcharging.
If the Jumpstarter fails to start your vehicle refer to the
clamp connection LED table on page 8 to review the
error. Additionally, check that the clamps are connected
correctly with good contact.
8
Turn the Jumpstarter off using the power button.
9
Disconnect the Black clamp and then the Red clamp.
