6
ASSEMBLING CHARGING LEADS TO BATTERY CLAMPS
The HDBC45 battery charger is shipped with the battery clamps disconnected from the
positive & negative charging leads.
IMPORTANT:
• The negative (Black) battery clamp must be connected to the charging lead
connected to the unit.
• The positive (Red) battery clamp must be connected to the bare copper end
of the second charging lead supplied. Connect the opposite end of the charging
lead to either the 12V or 24V outlet on the top panel of the battery charger via
the cable lug on the end of the charging lead.
To connect both the positive and negative leads to the battery clamps refer to the
instructions below:
1. Slide the rubber cover off the battery clamp handle.
2. Loosen the bolt located on the outside of the battery clamp handle using an
8mm socket.
3. Feed the bear copper end of the battery clamp lead through the battery clamp handle
and position underneath the rectangular nut as per the illustration below.
4. Refit & tighten bolt to create firm connection.
5. Slide the rubber cover back over the battery clamp handle.
