1
2
INSTALLATION INSTRUCTIONS
4
1.
Remove Existing Sink
A. Leave the faucet and drain outlet in place.
B. Shut off water supply valves (usually under sink).
C. Relieve pressure by opening hot and cold faucet
valves. Let water run until it stops flowing.
D. Disconnect the supply lines from the water supply
valves.
E. Disconnect the drain fitting from the waste trap.
F. Remove frame or rim fasteners around underside
of old sink.
G. Lift sink out with faucet and drain fitting still in place.
2.
Prepare an Existing Countertop
A. Make sure existing countertop cutout opening is
the proper size. Set the sink (A) into opening.
The rim of sink (A) should rest evenly on the
countertop. Note: Slight adjustments can be made
using a file or saber saw (not included). Use caution.
B. After final fitting, remove the sink (A) from cutout.
3.
Prepare a New Countertop (using sink as a template)
A. Carefully place the sink (A) upside down on the
countertop at the desired position. Trace the outline
of sink (A) on the countertop.
IMPORTANT NOTE: Do not cut along this line.
B. Draw a line 3/8 in. inside the sink outline.
Measure the cutout line you just drew and compare
to all sink dimensions. The cutout line should be
approximately 3/4 in. smaller than the
overall sink dimensions.
C. Drill a pilot hole inside the cutting line.
D. Using a jigsaw (not included), cut along the inside
line to cut the opening in the countertop.
3
Supply
Lines
Waste
Trap
Supply
Valves
Length
Width
Countertop
A
A
