It is important to periodically check the seals (G) to ensure maximum water sealing
performance. See Fig. 6.
Fig.6
Any repair that requires the dismantling of the projector assembly screws should only be
carried out by the manufacturer.
Replacing defective parts with non-genuine parts may render null and void the warranty.
CAUSE AND SOLUTIONS OF POSSIBLE PROBLEMS
-
The projector does not turn on
Check that the power grid is present.
-
Reduced brightness
can be caused by the end of the life-cycle of LED or the presence of dirt in the optical
elements. Perform an accurate cleanup of the optical elements, if the problem persists
contact PROIETTA customer service.
-
When the projector is connected to the electrical grid the magnetothermal switch
interrupt the current flow
The line magnetothermal is undersized compared to the characteristics of the projector.
It is necessary to bypass or replace the line magnetothermal.
-
Faulty projection
The gobo can be broken or dirt has been deposited on the surface of the gobo. Clean
up the gobo with an antistatic cloth and if the problem persists contact PROIETTA
customer service.
TIPS:
For best results from projections, project images onto dimly lit or dark surfaces,
avoiding reflective surfaces (e.g. mirrors).
When possible, always prefer light-colored surfaces.
6
G
