REST
is used to restore the default settings: press ENTER button followed by the
sequence: UP, DOWN, UP, DOWN; then press ENTER again to confirm (custom programs
are not overwritten).
Id
is used to enable the same function: press ENTER button followed by UP or DOWN
button to choose ON or OFF to enable/disable the ID address function.
RGb
is used to activate color cast correction switch settings: press ENTER button followed
by UP or DOWN button to choose ON or OFF to enable/disable the color cast correction
switch settings.
POW
allows to choose between
NORM
(33% = 1 W) e
HIGH
(100% = 3 W) power mode.
Please consider to avoid
HIGH
power mode if projecting steady colors at full values.
Static colors with values around 255 may reduce the lifespan of the single LEDs if
kept it on at
HIGH
power for a long time.
dIM
is a non-linear dimming speed setting (refer to “dimming speed table” at page 18).
It uses the 16-bit operating control board to gradually smooth, with different curves, the
dimming speed of the LEDs.
2.3.9 WHITE BALANCE SETTING (
CAL1
)
CAL1 WT.01
R.000
G.000
WT.11
b.000
To set the white balance presets press MENU until
CAL1
is displayed.
Press ENTER button followed by UP or DOWN buttons to choose one of the proposed
programmes. To modify Red, Green and Blue values press ENTER button repeatedly to choose
the value to modify and UP/DOWN to set it.
Please note:
when DMX channel mode is set on
STAG,
channel 6 can be used to select one of these programs
(
WT.01 - WT.11
).
14
(0-255)
(0-255)
(0-255)
